How do I apply the lash clusters?

Prep your natural lashes by removing any makeup or excess oils to maximize wear time.
Curl your natural lashes using a lash curler, then brush on a thin, even coat of bond under your natural lashes – a little goes a long way. Brush only in one direction, so lashes don’t stick to each other (near the root to the midpoint of the lash). For thinner lashes, apply 2 coats. For thick lashes, apply 1 coat. Then wait 20-30 seconds for the bond to become tacky on your lashes.
Using the lash grab, gently apply each cluster underneath the base of your natural lashes, slightly away from the waterline to avoid possible irritation.
Once you’re satisfied with your application, you can merge both the band and the strands of each segment with your natural lashes using the lash grab to bind your lashes and clusters together.
To remove any residue, apply a thin coat of the seal above and below the lashes, and wherever you feel excess stickiness.

GLAM TIPS:

For additional holding power, apply the bond on the upper side of each cluster before placing it on your natural lashes
Leave a few natural lashes free on the outer corner while applying the first cluster, to ensure the most natural placement. Do not leave gaps between each lash segment as you work your way to the inner corner.
Before adding bond to natural lashes, detach the lash clusters from the tray for easier and smoother application.
After adding the Bond to the base of the natural lash, add a thin layer of Bond to the band of the lash cluster as well, prior to application. Let it dry for 20-30 seconds, then apply the lash clusters to the natural lash. Adding extra adhesive to the band can increase the longevity of the lash extensions.
When applying the Seal, use the fuzzy ball tip to run it along the very base of the lashes where the Bond is the stickiest. Use the brush applicator to apply the Seal to the entire length of the lashes, from root to tip.
After lashes are applied, wait 24 hours before showering and exposing it to steam. When taking a shower or washing your face, avoid directly splashing water onto the eyes.
Use Glamnetic’s Cotton Candy Pads to clean the eye area around the lashes to prevent oils from touching the lashes as it could break up the bond and decrease wear time.
Avoid sleeping on your face as it could affect the longevity of the lash extensions
If the lash clusters loosen up after days of wear, apply a thin coat of Bond on the band, and use the lash grab to merge together with the natural lash. This will extend the wear of the clusters.
Do not peel off lash clusters from natural lashes! Use the Bond Remover for effective removal

How do I apply the lash clusters?Updated 10 months ago